Setting Up an Overlocker

Setting Up an Overlocker

Overlockers can look a little intimidating at first, with all those threads, dials and guides. But don't worry, the overlocker is your friend. In this video tutorial, Steve walks you through setting up and threading an overlocker so you can get started with confidence.

Getting to know your overlocker

An overlocker (sometimes called a serger) stitches, trims and neatens a seam all in one pass. It's brilliant for knits and for giving your seams a shop bought finish. Most domestic overlockers use three or four threads, and the main parts are:

  • Needles: usually two, a left and a right. Using both gives a wider, stronger four thread stitch.
  • Loopers: an upper and a lower looper, which wrap thread around the edge of the fabric.
  • Knives: these trim the fabric edge just before it's stitched.
  • Tension dials: one for each thread, so you can balance the stitch.
  • Differential feed: controls how the fabric feeds through, to stop stretchy fabric rippling or fine fabric puckering.

Threading step by step

Threading is the part that worries people most, but it's simply a case of following the guides in the right order. Every overlocker is a little different, so keep your manual to hand.

  1. Raise the presser foot. This opens the tension discs so the thread can seat properly.
  2. Set up your cones. Pull up the telescopic thread guide fully and place a cone on each spool pin.
  3. Follow the colour codes. Most machines have a colour coded path for each thread, printed inside the front cover.
  4. Thread in order. Thread the loopers before the needles, in the order shown in your manual. Getting the order wrong is one of the most common reasons threads tangle or snap.
  5. Floss the tension discs. As you pass each thread through its tension dial, hold it either side and give it a gentle tug so it sits right down between the discs.
  6. Thread the needles last. Thread the right needle and then the left, or as your manual shows.
  7. Make a thread chain. Pull all the threads under and behind the foot, lower the foot and turn the handwheel a few times. Then run the machine gently until a neat chain forms.

Before you start sewing

  • Test on a scrap. Always try your stitch on a piece of the fabric you're using, and adjust the tensions one dial at a time until the loops meet neatly at the edge.
  • Use different colours to learn. Threading each position with a different colour makes it much easier to see which thread needs adjusting.
  • The tie on trick. When changing colour, cut the old threads near the cones, tie on the new ones and gently pull them through. Untie the knots before they reach the needle eyes and thread the needles by hand.
  • Keep it clean. Overlockers make plenty of lint, so brush out the looper area regularly.

If threading is putting you off, it's worth knowing that some overlockers thread the loopers with a puff of air, such as the Brother Airflow 3000. You can see all our models in our overlockers collection.

If you have any questions, or you'd like help choosing a machine, try our Machine Match or give us a call on 01553 773362.

Give it a go, and you'll soon wonder how you sewed without one.

Back to blog