Inserting a Concealed Zip
Share
A concealed zip, often called an invisible zip, is a simple and secure way to finish a project, but getting it really neat can be tricky. When it's done well, all you see from the outside is a seam and a little pull at the top. Here's how to insert one for a lovely clean finish.
What you'll need
- A concealed (invisible) zip, a little longer than your opening
- A concealed zipper foot, which has grooves that ride over the zip coil
- A standard zipper foot for finishing the seam
- Thread to match your fabric, pins and an iron
Step by step
Unlike a standard zip, a concealed zip goes in before you sew the rest of the seam.
- Finish the edges. Neaten the raw edges of the seam allowances with an overlocker or zigzag stitch.
- Press the coil open. Open the zip and, working from the back, press the coil gently with a cool iron so it unrolls a little. This lets you stitch closer to the teeth.
- Pin the first side. With the zip open, place it face down on the right side of one piece of fabric, with the coil lying along the seamline and the top of the zip at the top edge. Pin or tack it in place.
- Stitch the first side. Fit the concealed zipper foot so the coil sits in its groove. Sew from the top down, as far as you can until the foot reaches the slider.
- Pin the second side. Close the zip to check it lines up, then open it again and pin the other side to the second piece of fabric in the same way. Make sure the zip isn't twisted and any waistbands or seams match across the opening.
- Stitch the second side. Sew from the top down again, using the other groove in the foot, and stop at the same point.
- Close the seam below. Close the zip and switch to a standard zipper foot. Pull the end of the zip out of the way, then sew the rest of the seam, starting just above and slightly to the side of your last line of stitching.
- Secure the zip ends. Stitch the bottom of each zip tape to its seam allowance so it doesn't flap about inside.
- Press. Press the seam from the wrong side, keeping the iron off the zip coil.
Handy tips
- Go slowly near the slider. The closer you get to the coil, the more invisible the zip, but stitching onto the coil itself will stop it running smoothly.
- Buy a longer zip. A zip a few centimetres longer than the opening makes it much easier to stitch past the slider area.
- Interface lightweight fabrics. A narrow strip of light fusible interfacing along the seam allowance helps stop puckering.
You'll find concealed zipper feet in our machine feet range, such as the Janome concealed zipper foot and the Bernina 35V invisible zipper foot.
If you have any questions, or you'd like help choosing a machine, try our Machine Match or give us a call on 01553 773362.
Enjoy that lovely, professional finish.