Bernina 4V zipper foot

Insert a Simple Zip

Sometimes you just need to get a job done, and function matters more than fashion. Fitting a simple centred zip with your sewing machine is a great everyday technique for cushion covers, bags, skirts and repairs, and it's much easier than it looks. Here's how to do it, step by step.

What you'll need

  • A zip at least as long as your opening
  • A zipper foot, which lets you stitch close to the zip teeth
  • Thread to match your fabric
  • Pins, an iron and a seam ripper

Step by step

  1. Finish the edges. Neaten the seam allowances with an overlocker or a zigzag stitch before you start, as they're hard to reach once the zip is in.
  2. Mark the opening. Lay the zip against the seam and mark where the bottom stop sits.
  3. Sew the seam. With right sides together, sew the seam below the mark with your normal stitch length and secure it with a few reverse stitches. Then switch to the longest straight stitch and sew the zip opening closed. This long tacking stitch holds everything in line while you work.
  4. Press the seam open. Press the seam allowances flat and open from the wrong side.
  5. Position the zip. Place the zip face down on the pressed seam, with the teeth centred exactly over the seamline. Pin or tack it in place.
  6. Fit the zipper foot. Swap to your zipper foot and set the needle position so it stitches close to, but not on, the teeth.
  7. Stitch it in. Working from the right side, sew down one side of the zip, pivot at the bottom and stitch across below the stop, pivot again and sew up the other side.
  8. Move the slider out of the way. When the zip pull gets in the way, stop with the needle down, lift the presser foot and slide the pull past the foot, then carry on.
  9. Open it up. Unpick the long tacking stitches with a seam ripper to reveal your zip, then give it a final press.

Handy tips

  • Too long? Nylon coil zips can be shortened from the bottom. Stitch a few bar tacks across the coil where you want the new stop, then trim below it.
  • Keep it straight. A strip of tape on the right side, centred over the seam, gives you a handy line to stitch along.
  • Take it slowly around the bottom corners, and use the handwheel if you need to step over the zip.

If your machine didn't come with a zipper foot, you'll find one in our machine feet range, such as the Janome adjustable zipper foot or the Bernina 4V zipper foot.

If you have any questions, or you'd like help choosing a machine, try our Machine Match or give us a call on 01553 773362.

Once you've fitted one, zips won't hold any fear. Happy sewing.

Back to blog