Threading a sewing machine

How to Thread a Sewing Machine (Step by Step)

Threading a sewing machine can feel fiddly at first, but it quickly becomes second nature. Whether you are brand new to sewing or have just got a new machine, this guide takes you through it calmly and clearly.

Threading a sewing machine

These steps apply to most modern machines, including Brother, Janome, Bernina, Juki and Singer. Your manual will always have the exact diagram for your model, and if you have a Brother machine and have lost yours, Brother keeps a full library of manuals on its Brother support site.

What you will need

  • Your reel of thread.
  • Your machine switched off, or with the needle in the up position.
  • A bobbin. We cover winding one in step 5, so if you already have a wound bobbin in place, you are ready to go.

Threading your machine

  1. Raise the presser foot. This is the step people most often forget. Lift the presser foot lever, usually found at the back on the right hand side. Raising it opens the tension discs so the thread can seat properly between them. If you skip this, you are likely to get uneven or loopy stitches.
  2. Place your thread spool. Put your thread on the spool pin at the top of the machine. The pin may be horizontal or vertical. If it is horizontal, fit the spool cap on the end so the thread does not unwind too quickly.
  3. Follow the threading path. Most modern machines have numbered guides or arrows printed on the body, so follow them in order. On most machines the thread goes from the spool through the first guide at the top, down around the tension channel, back up through the take up lever (the hook shaped arm that moves up and down as you sew), then down through the remaining guides to the needle. Many Brother and Janome machines also have the threading diagram on a sticker inside the accessory compartment.
  4. Thread the needle. Most machines thread from front to back, though some go from left to right. Leave a tail of about 10 to 15 centimetres. If your machine has an automatic needle threader, lower the lever gently, check the thread is sitting in the little hook, then release it slowly. It takes a little practice, so do not worry if it does not work first time.
  5. Wind and insert your bobbin. To wind a bobbin, place an empty one on the bobbin winder pin at the top of the machine, take the thread around the bobbin winding tension guide and push the pin across into the winding position. Hold the thread end, run the machine slowly until the bobbin is full, trim the thread and push the pin back. To insert it, open the cover or slide plate (this varies by machine) and drop or slide the bobbin in. Most modern machines use a top loading drop in bobbin under a clear cover. Follow the diagram on the cover and check the thread is unwinding in the right direction.
  6. Bring up the bobbin thread. Holding the top thread lightly, turn the handwheel towards you so the needle goes down into the bobbin area and comes back up again. It will catch the bobbin thread and bring up a loop. Gently pull the loop out so both threads come out from under the presser foot together, then draw both threads to the back under the foot. You are ready to sew.

A quick note on tension

If your stitches look loopy on the top or underneath after threading, nine times out of ten the cause is threading rather than tension. Go back to step 1, raise the presser foot and rethread from scratch before touching any dials. That usually sorts it.

Still not sure? We are here to help

If you are threading correctly and your stitching still is not right, your machine may need a service. You can book your machine in with our servicing team and we will give you a time estimate.

If you are still choosing your first machine, we have over 50 machines on our showroom floor in King's Lynn and are always happy to show you how threading and tension work before you buy. If you'd like help choosing, try our Machine Match or give us a call on 01553 773362.

Back to blog